Ford Sterling 10.25/10.5 to Toyota Forged Drive Line Flange

If you are putting a Ford Sterling in your Toyota rock crawler, buggy, or daily driver, this is the yoke you will need to retain your stock driveshaft. It will accept the late 80's or early 90's Toyota Non CV bolt pattern drivelines. It is forged and comes with all necessary hardware, including a new pinion nut and seal!

The yoke kit includes:

• Flange with 3 bolt patterns (see below)
• New pinion seal
• New pinion nut
• New metric drive line bolts, nuts, and washers
• Factory style dust sleeve installed on yoke

60 x 60mm, 10mm hole
• 84-95 U-joint
• FJ80 & LX450 front
• 79-83 U-joint (these were 8mm, driveline will need to be drilled to 10mm)

56 x 64mm, 10mm hole
• FJ/HJ/BJ Landcruisers
• 79-83 pickups had 8mm holes, driveline will need to be drilled to 10mm

66 x 66mm, 11mm hole
• 86-87 Turbo
• 88 & up V6
• FJ60