ABS Pigtail to Convert Ford '05+ Axle to Chevy Classic Body Style Wiring Harness

This ABS pigtail extension allows you to extend your factory GM ABS sensor harness. This is used in the (1999-2007.5) Classic body style GMT800 truck. No more wasting time splicing wires and hoping you have it correct. If you have a '99-'05 truck with a 45 degree ABS sensor, we recommend using the GM ABS sensor with the 90 degree ABS sensor on the unit bearing side. GM part number 19300584. 

From end to end the pigtail measures 26" long.

***Disclaimer***

There are a couple of different style sensors out there depending on the make, model, and year vehicle you have. Because ABS is tricky, one person's setup may not work for another. So, the best bet is if you have your old sensors still laying around to try them first. There are 2 different Chevy/GMC style sensors, a tall profile 45 degree sensor and a low profile 90 degree sensor. You can easily pop the low profile sensor, usually found in the '06-'07 year trucks, in your Ford hub and will read just fine. The tall profile sensor, usually '01-'05 year trucks, will not work - it rubs the inside of the rotor.  If none of these options work, then you need to look further and check to see if you have a cut or melted wire in your truck harness from removal of the stock IFS lift. Also, there are numerous types of aftermarket programmers that can easily mess with the signal of the ABS system. You may either have to re-program or uninstall your programmer, check the ABS system for codes, and then see if it’s a wiring issue or a programming issue.