Full High Steer Inverted T Kit With Tubing

WFO Inverted T Kit - This kit comes with everything you need to complete your steering set up.  We created this kit without steering arms for those customers who already have them.  If you need steering arms, check out our selection of steering arms. 

This kit is set up for single holed steering arms.  We use a double pivot drag link end at the pitman arm to maximize the amount of articulation that can be achieved.  The drag link comes from the pitman arm and ties into the tie rod end on the passenger's side (it does not connect into the tubing).  The tie rod uses a tie rod end at the driver's side and a special tie rod end at the passenger's side that the drag link connects into.  Both tubes are made of 1.5" O.D., .250" wall DOM tubing.  You cut the tube to length, weld in the supplied tube inserts, thread the tie rod and drag link ends in, set your toe, and your finished!

Our tube inserts are built with a hex for easy adjustment of the tie rod and drag link.  The tubing comes long enough for almost all applications.  If you think you're going to need more tubing, call us and we'll get you what you need.  All of the draglink & tierod ends are MADE IN AMERICA by MOOG.

Kit Includes:

For the Drag Link:

1. Double pivot drag link end for the pitman arm
2. Three feet of .250" wall DOM tubing
3. Tie rod end for steering arm
4. Tube inserts for .250" tubing
5. Two jam nuts

For the Tie Rod:

1. Tie rod end for steering arm on the driver's side
2. Four feet of .250" wall DOM tubing
3. Tie rod end for passenger's side.
4. Tube inserts for .250" tubing
5. Two jam nuts

MADE IN THE USA!

Welding required.