Adjustable Leaf Spring Perches, Weld-On

If you have ever needed to fine tune your axle location, then these adjustable spring perches are for you! These CNC machined, adjustable, Weld-on, leaf spring perches are something we have been wanting to make for a long time! No matter how much measuring a fabricator can do, the axle location always seems to end up "just a little off". Especially when fitting the largest tires possible in a factory wheel opening! Not to mention, many hotrod or 4x4 chassis never seem to be square. With these new perches installed on your axle, you will no longer need to worry about the perfect leaf spring location. The tightest wheel well or alignment adjustments can be done in a matter of minutes!

Spend the money up front to save time and money later! A simple rear axle, body trim, or chassis adjustment can be very costly at the end of a project. Set yourself up for success!

These can be used for off-road or hot rod vehicles! There are no limitations.

Designed for 3" axle tubes, but can easily be modified with a grinder to fit down to 2 3/4" and up to 4" tubes.

Can move the axle location 1.5" in either direction.

Warning: In order to move the axle forward or backward with these perches, your leaf spring plate will need to be clearanced or drilled for center pin movement. A new hole will need to be drilled in the final location desired, or your plates will need to be slit. Keep in mind that we sell new top plates with multiple center pin locations in them. Our WFO 1797 - 2.5" Leaf Spring Plate is specifically made for use with this adjustable perch!

Sold as a pair.

Includes:
-2 Weld-on adjustable spring perches with 3" of movement
-CNC machined perch and slider with zinc plated slider
-Grade B10 hardware with fine thread socket head cap screw adjuster
-Mig welded 3" diameter axle tube stand-offs
-Radius machined on ends to work with spring over or spring under application

MADE IN THE USA!